JASCO 17528T Under Cabinet Light Fixture
Lightbars can be turned on with the remote or by manually switching on and off.
Manual Operation: Slide control switch to on or off position for manual use.
Remote Operation: Before using the remote for the first time, remove the clear plastic tab inside the remote control battery compartment. Slide the switch to the RF (radio frequency) position. Push the remote switch to turn lights on and off.
NOTE: If lights should become out of sync with the remote control, simply turn all light bars off manually by sliding the control switch to OFF, then back to RF to reset. Turn them back on using remote control. If the light has been turned on manually, the remote will not turn in off.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.