JOHN LEWIS Fluted Hoop LED Pendant User Guide
Introduction
Thank you for purchasing this Fluted Hoop Led Pendant.
Please read the instructions carefully before use to ensure safe and satisfactory operation of this product.
Warnings
This product is Class I and must be earthed.
For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by law, consult a competent person who is registered with an electrical self-certification scheme. Further Information is available online or from your Local Authority
To prevent electric shock, switch off at the mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electricity supply without your knowledge.
If you are in any doubt, please consult a qualified electrician.
It is the installer’s responsibility to ensure that the fixings and plugs used are suitable for the surface you are fixing your product on.
If replacing an existing fitting, make a note of the connections.
The flexible cable on this luminaire, if damaged, shall only be replaced by the manufacturer or his service agent or a similar qualified person.
CAUTION! The LED Module and surrounding parts can become hot during use.
Parts list
Integrated LED
- LED Lifespan: Up to 25,000 hours
- Colour Temperature: Bright Light How Bright?
45Watt / 2025 Lumens LED Non replaceable
Product assembly
Ensure the mains electricity supply switched off at the fuse board.
Step 1
If removing an existing fitting, note down all wiring connections.
Ensure that the bracket (supplied) is fixed to a wooden joist in the ceiling using screws (supplied) or use a suitable fixing to the ceiling which will support the weight of the fitting.
The weight of the fitting must be supported by the suspension bracket and not the flexible cable.
Step 2
Connect cables to terminals as shown below.
Check all wires are tight in the terminal block and no loose strands are left out.
Cover with insulating tape (not included).
Step 3
Push up ceiling cup and secure with metal grub screws.
Step 4
To adjust the height of the fitting, press centre of the bushes; this will allow the cable to move up and down to the height required.
Switch on the electricity supply at the fuse board.
Caring for your product
We recommend cleaning with a soft dry cloth.
Do not use abrasive materials as these will damage the finish.
Aftercare and Troubleshooting
Why is the light not working when switched on?
Check your power supply is switched on
If you experience any unresolvable technical issues with the product, contact your nearest John Lewis & Partners shop or John Lewis & Partner Technical Support on 03301 230106.
Specification
- Integrated Led energy efficient LED Module
- Max. power: 1x 45W
- LED light source included
- Voltage: 220 –240V, 50Hz
- IP rating: 20
- Weight: 2.8kg
5 year guarantee
At John Lewis & Partners we test every light to high quality standards so we are able to offer you a 5 year guarantee.
Recycling
This symbol 
indicates that this product should not be treated as normal household waste and it should be recycled. John Lewis & Partners do not operate instore take back, but as members of the Distributor Take Back scheme have funded the development and upgrade of recycling facilities across the UK. Please take it to your nearest collection facility or for further details contact your local council or visit www.recycle-more.co.uk.
John Lewis Partnership
171 Victoria Street
London SW1E 5NN
johnlewis.com
Made in China
Read More About This Manual & Download PDF:
Recycle More