lEDYi Lighting RS1 Touch Wheel RF Remote Controller
Touch Wheel RF Remote Controller
Model No.: RS1/RS2/RS6
13-Key/4 Zone/Touch color wheel/Wireless remote 30m distance/AAAx2 battery/Magnet stuck fix
Features
- Apply to single color or dual color LED controller.
- Ultra sensitive color adjustment touch wheel.
- Each remote can match one or more receiver.
- AAAx2 battery powered.
- Operate with LED indicator light.
- Magnet on the back which can be stuck on back holder.
Technical Parameters
Input and Output | |
Output signal | RF(2.4GHz) |
Working voltage | 3VDC(AAAx2) |
Working current | <5mA |
Standby current | <10μA |
Standby time | 1 year |
Remote distance | 30m(Barrier-free space) |
Safety and EMC | |
EMC standard (EMC) | ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4 |
Safety standard(LVD) | EN 62368-1:2020+A11:2020 |
Radio Equipment(RED) | ETSI EN 300 328 V2.2.2 |
Certification | CE,EMC,LVD,RED |
Weight | |
Net weight | 57g |
Gross weight | 111g |
Mechanical Structures and Installations
To fix the remote, three options are offered for selection: Option 1: stuck the remote on any metal surfaces directly. Option 2: fix the remote’ back holder on the wall with two screws. Option 3: adhere the remote’ back holder to the wall with paster.
Operation
- When turn on light, the indicator display blue. when turn off light, the indicator display red.
- When touch the color wheel, the indicator will display the same color.
- When press or touch operation is invalid (If the light is off), the indicator display red.
- To extend battery life, no touch or press key operation after a few seconds, the touch wheel will enter sleep state, you need press any key to make touch wheel quit sleep state.
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
Match: Short press match key, immediately press zone on key of the remote. The LED indicator fast flash a few times means match is successful.
Delete: Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.
Use Power Restart
Match: Switch off the power, then switch on power, repeat again. Immediately short press zone on key 3 times on the remote. The light blinks 3 times means match is successful.
Delete: Switch off the power, then switch on power, repeat again. Immediately short press zone on key 5 times on the remote. The light blinks 5 times means all matched remotes were deleted.
Key function
RS1 4 zone dimmer remote
RS2 4 zone color temperature remote
RS6 4 channel dimming remote
Note:
RS6 match with 4 channel receiver only, such as V4, each channel connect with one single color LED strip.
Safety information
- Read all instructions carefully before you begin this installation.
- When installing battery, pay attention to the battery positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
- If no response from the receiver, please re-match the remote.
- Gently handle remote, beware of falling.
- For indoor and dry location use only.