MEEC TOOLS 013148 20-110 Nm Torque Wrench Instruction Manual

MEEC TOOLS 013148 20-110 Nm Torque Wrench

SAFETY INSTRUCTIONS

• If the product is not correctly calibrated there is a risk of damaging the product, parts and/or fasteners.
• The product must be calibrated regularly to ensure it is completely accurate.
• Do not exceed the set torque, this can result in a risk of damaging the product and/or parts.
• Do not use the product to remove jammed fasteners.
• Do not use an extension on the handle to increase the torque. Risk of personal injury if the product breaks or slips.
• Never lubricate the inner mechanism on the product.
• Do not immerse the product in water or any other liquid.
• Do not attempt to set a lower torque than the lowest marked setting.

SYMBOLS

TECHNICAL DATA

• Measuring range 20 – 110 Nm
• Socket 3/8″

DESCRIPTION

Torque wrench with ratchet and 3/8″ square drive. The wrench is reversible and controlled tightening takes place by means of a click system that triggers a tactile and audio prompt to counteract overtightening.

The measurement range is 20-110 Nm with an accuracy of ±4%. Excellent tool for the repair and maintenance of vehicles as the bolts can be set with high precision.

USE

1. Release the adjuster mechanism by undoing the locking screws. FIG. 1
2. Turn the handle clockwise to increase, or anticlockwise to reduce the set torque.
3. The product has two scales. The set torque consists of the sum of the settings on both scales. For example to set 56 Nm, turn the handle until the edge of the adjuster ring is at the line for 50 and the line for 0 is in lie with the vertical line.FIG. 2
4. The set torque is then 50 Nm. Turn the adjuster ring until the line for 6 is in line with the vertical line.FIG. 3
5. Tighten the locking screws when the required torque has been set.
6. When tightening fasteners, hold the handle and tighten in the required direction until it clicks and you feel a jolt.FIG. 4

MAINTENANCE

• Clean product with a soft cloth. Do not use a detergent that can affect the lubricant in the product.
• Store the product in its case, set to the lowest torque to relieve the spring.
• The internal spring in the product must be tensioned to retain precision. To tension, the spring, lock the product head in a vice or with an attached fastener and move the handle clockwise until it clicks.