nilfisk food BF16 Multi Booster Owner’s Manual

nilfisk food BF16 Multi Booster Owner’s Manual & troubleshooting

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 1

Multi Booster
BF16, BF24, BF32, BF40, BF48,
BF16T, BF24T, BF32T, BF40T, BF48T.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 2

Service Manual (original)
Spare part list

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 3

Description

The Booster in the Chameleon Plus range is a completely functioning pumping station that supplies pressurised water to connected satellite hygiene stations. Therefore the Booster must be supplied with water in sufficient quantity and power according to specifications.
The station is then ready for hygiene duties. The Booster is fitted with a frequency-controlled pump which ensures a constant working pressure independent of usage pattern.

Important: Do not use the water from the system for applications other than cleaning.

A typical Floor Booster installation is shown in fig. 2

  • Booster (1)
  • Satellite (2)

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 4

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 5

1.7 Multi Booster BF16 – BF24

1. Water inlet
2. Manifold inlet
3. Trigger sensor, flow sensor
4. Pump
5. Manifold outlet
6. Outlet pipe
7. Inverter box
8. Filter box
9. Electrical connection box
10. Floor bracket
11. Inlet ball valve
12. Outlet ball valve
13. Operation panel
14. Strainer
15. Non Return Valve
16. Pressure sensor
17. Display
18. Navigation buttoms
19. Label
20. Name Label
21. • O Pushbutton.Stop
22. • I Pushbutton.Start
23. • Δ Lamp. Alight by error
24. Pressure sensor

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 6

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 7

1.3 Advanced Booster BF32 – BF40 – BF48

1. Water inlet
2. Manifold inlet
3. Trigger sensor, flow sensor
4. Pump
5. Manifold outlet
6. Outlet pipe
7. Inverter box
8. Filter box
9. Electrical connection box
10. Floor bracket
11. Inlet ball valve
12. Outlet ball valve
13. Operation panel
14. Strainer
15. Non Return Valve
16. Pressure sensor
17. Display
18. Navigation buttoms
19. Label
20. Name Label
21. • O Pushbutton.Stop
22. • I Pushbutton.Start
23. • Δ Lamp. Alight by error
24. Non-return valve for by-pass
25. By-pass
26. Pressure sensor

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 8

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 9

1.3 Operating Diagrams acc. ISO14617

Multi Booster BF16 – BF24 – BF32 – BF40 – BF48

B. Ball valve.
F.  Filter
FST. Flow switch.
C. Check valve.
PE. Pressure sensor.
TE. Temperature sensor.
CP. Centrifugal pump.
D. Outlet.
PU. Pump unit.
W. Water inlet.
SN : Socket no.

Maintenance

The Booster unit is maintenance-free. However, we recommend cleaning the booster unit in connection with the occasional cleaning of the other equipment in the area. The filter must be cleaned at convenient intervals (approx. every 1-3 months) depending of the amount of impurities in the water.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 10

Filter
  1. Press “0” on the control panel to stop the Booster.
  2. Interrupt the master switch (Fig. 1).
  3. Close the water inlet .
  4. Open a tap to release the system of pressure.
  5. Remove the filter (A, Fig. 2) and place it in a descaling solution.
    Note: MB systems are not delivered with a factory mounted filter. In case a filter is
    nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 11mounted in a MB system, the descaling procedure is exactly the same until the scale is dis- solved.
  6. Rinse the cleaned filter thoroughly and remount.
  7. Min filter mesh size 800µ -> 1500μ.
Before a longer production stop

If long production stops are planned (more than 6 months) and the pump is drained, it is recommended that the pump is secured as follows:

  1. Remove the coupling safety guard.
  2. Spray a couple of drops of silicone oil onto the axle between the top section and the coupling.

Carefully follow the instructions given in the manual provided by the pump supplier.

Start

New system

In order to ensure a problem-free start up of a new system the pipe system must be flushed and bled.

Bleeding the pipe system

  1. Turn on the water supply to rinse and bleed the entire system. If satellites are installed open the tap furthest away until no air or dirt comes out. Then rinse and bleed the next tap and continue until the tap closest to you has been rinsed and bled.
  2. Mount satellites, if any
    Bleeding the pump
  3. Press “0” on the control panel to stop the Booster.
  4. Loosen the relief plug (A, Fig34) 1-2 revolutions until water and air begin to flow out.
    Note. Never loosen the relief plug while the pump is running as this may damage the packing and cause personal injury.
  5. Tighten the relief plug again
  6. Start the pump so that all re- maining air pockets are forced up to the top of the pump.
    nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 12nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 13
  7. Stop the pump.
  8. Loosen the relief plug 1-2 revolutions again and bleed the system until only water flows out.
  9. Tighten the relief plug once more. The Booster is now ready for operation. Press “I” on the control panel. (see fig. 4).

Daily operation

Start
  1. Check that water supplies for the system are open.
  2. Press “I” on the control board in order to start up the unit.
Stop
  1. Press “0” on the control panel to stop.
  2. Turn off the water supply.
  3. Switch off the air supply.

Note. Due to the following it is very important always to switch off both water and air supply after use:

  • If the air supply is open when the main station or satellites are not in use, air might leak into the water line. If this happens, the system must be bled once more.
  • The water separator, which is a part of the air regulator, is only to be emptied when the air supply is closed.

After a long time production stop (holidays etc) it might be necessary to bleed the piping system and the booster unit again.

Service

Service may only be carried out by  authorized and qualified personnel.

Warning: The system must only be serviced when there is no voltage or pressure on the system.

  1. Turn off the main switch at the control box (Fig. 1)
  2. Open a water outlet to depressurise the system.
Components

Pump/motor
Pump/motor are maintenance-free, see section 2.2

Control system
Maintenance-free If defective: Call service technician

Flow trigger
Maintenance-free. If defective, replace the flow switch. The orientation of the flow switch has to be done in such way that the plug/cable end of the switch is pointing opposite the flow direction.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 14

Adjustment of flow switch
When the flow switch is replaced/installed it has to be adjusted.

  1. Press “1” on the control panel to turn on the machine.
  2. Turn “rinse/foam” handle on a satellite to foam position.
  3. Activate the spray handle on the outlet hose of the satellite so water runs out.
  4. Check that the flow switch is turned the correct way (the wire must be opposite the flow direction) (see picture).
  5. Remove the white plug/screw before adjusting (see picture).
  6. Adjust the flow to one green diode lights up (see picture).
  7. Close the spray handle again and check that the red diode lights up.
  8. Remount the white plug/screw. The flow switch is now adjusted.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 15

Non-return valve / inlet side
Maintenance – free.
If defective, replace the non-return valve.

Recycling and scrapping

Recycle the wrapping and scrap the machine according to recommendations from the local authorities.

Troubleshooting

The unit does not start

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 16

The “Δ”- lamp on the control panel is on

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 17

If the inlet pressure is low or unstable

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 18

Recommended spare parts

The recommended spare parts are marked with * in the spare part manual.

Specifications

Technical Data Multi Booster.
BF16 BF24 BF32 BF40 BF48
Max. Outlet pressure. bar 25* 25* 25* 25* 25*
Consumption during rinsing. Umin 440 660 880 1100 1320
Consumption during foaming. Umin 160 240 320 400 480
Min. supply pressure. bar 2 2 2 2 2
Max. supply pressure. bar 8 8 8 8 8
Min. water supply. Umin 500 750 1000 1250 1500
Max. water temp. °C 70 70 70 70 70
Pipe dimension inlet 0 inch 2 1/2″ 3″ 4″ 4″ 4″
Pipe dimension outlet 0 inch 2 1/2″ 3″ 4″ 4″ 4″
Electricity
Supply voltage V 3/PE 400 V ±10%
Frequency Hz 50±2
Motor load (kW) kW 22 33 44 55 66
Installation to EN 60204-1
Nominal current A 55 82,5 110 137,5 165
Fuse A 63 100 125 160 200
L1, L2, L3, PE mm2 3. 3. 2,5 6 6
General
Sound level ISO 11202 dB 85 dB
Dimensions mm 1112x530x1043 1112x530x1477 1268x665x2399 1268 x 665 x 2822 1268 x 665 x 3248
Weight (kg) ca kg 190 300 400 500 600

Note:
* Pump pressure 20 bar + inlet pressure max. 25 bar

Electric diagram

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 19

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 20

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 21

Pump curve

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 22

Declaration of Conformity

BF16, BF24, BF32, BF40, BF48

Declaration of Conformity

Nilfisk FOOD Blytækkervej 2 9000 Aalborg Danmark

We Nilfisk FOOD, declare under our sole responsibility that the products BF16+, BF24+, BF32+, BF40+, BF48+, to which this declaration relates, are in conformity with these Council directives on the approximation of the laws of the EC menber states:

Function: Pumping Station
Model/Type: BF16-2+, BF24-3+, BF32-4+, BF40-5+, BF48-6+.
Serial number: All

Machinery Directive (2006/42/EC:2006-05-17).
Standard used: EN 60335-2-41/A2:2010

EMC Directive (2004/108/EC:2004-12-15).
Standard used: EN 55014-1/A1:2009 and EN 55014-2/A2:2008
Standard used: EN 61000-3-2/A2:2009 and EN 61000-3-3:2008

Technical file responsible:
Flemming Asp
Nilfisk FOOD
Blytaekkervej 2
9000 Aalborg, Denmark

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 23

Spare parts

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 24

* Recommended spare parts
▲ Min. order size is 10 pcs.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 25

* Recommended spare parts
▲ Min. order size is 10 pcs.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 26

* Recommended spare parts
▲ Min. order size is 10 pcs

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 27

* Recommended spare parts
▲ Min. order size is 10 pcs. / Min.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 28

* Recommended spare parts
▲ Min. order size is 10 pcs.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 29

* Recommended spare parts
▲ Min. order size is 10 pcs.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 30

* Recommended spare parts
▲ Min. order size is 10 pcs.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 31

* Recommended spare parts
▲ Min. order size is 10 pcs.

nilfisk food BF16 Multi Booster Owner’s Manual  & troubleshooting 32

No.: 110008335A 10/2021
Serial no.: 151.01.000XXX
Printed in Denmark

FAQ


Setting up nilfisk food BF16 Multi Booster Owner’s Manual is easy with these step-by-step instructions. Follow the steps are you are set-up in no time.

Using nilfisk food BF16 Multi Booster Owner’s Manual is simple by using this manual. Follow the instructions one by one and everything will be fine

Is nilfisk food BF16 Multi Booster Owner’s Manual stuck or not working properly? By resetting it you can set it back to the standard settings and everything should be back to normal. This works in many cases when problems arise.

This page contains the complete user instructions & manual for nilfisk food BF16 Multi Booster Owner’s Manual

All symbols, colors and codes for nilfisk food BF16 Multi Booster Owner’s Manual are explained in this instruction manual. You can find everything you need and moree