REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
Conforms to / Conforme: UL 2075
Certified to / Certificada: CSA STD 6-19:2001, ULC STD S529
Other Standards / Otras normas: RoHS
WEEE Directive 2012/19/EU Waste of Electrical and Electronic Equipment Directive Disposal Information
Do not dispose of this device and contained batteries with the general household waste, For proper treatment, recovery, and recycling, please take the device and contained batteries to designated collection points, Disposing of this device and of contained batteries correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling.
Actuation of this device indicates the presence of carbon monoxide (CO) which can KILL YOU. If alarm signal sounds (3 pulses for Fire/Heat and 4 pulses for CO): (1) immediately move to fresh air – outdoors or by an open door or window. Check that all persons are accounted for. Do not re-enter the premises or move away from the open door/window until the emergency services responders have arrived, the premises have been aired out, and your alarm remains in its normal condition; (2) call your emergency local (fire department or 911) If “service” signal sounds (See “LED Indication & Sounder during Test and Trouble” Table) take appropriate action for each signal.
Installation of the device should not be used as a substitute for proper installation, use, and maintenance of fuel-burning appliances, including appropriate ventilation and exhaust systems.
This device will only indicate the presence of carbon monoxide gas at the sensor. Carbon monoxide gas may be present in other areas. This device is designed to protect individuals from the acute effects of carbon monoxide exposure. It will not fully safeguard individuals with specific medical conditions. If in doubt consult a medical practitioner
NOTE: The replacement date that appears on the device is the date beyond which the device may no longer detect carbon monoxide accurately and should be immediately replaced
FEDERAL COMMUNICATIONS COMMISSION
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User’s Manual. Unauthorized changes or modifications could void the user’s authority to operate the equipment.
CLASS B DIGITAL DEVICE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, as defined by FCC Rules Part 15.105. The Class B Digital Device
statement can be viewed at: https://customer.resideo.com/enUS/support/residential/codes-and-standards/FCC15105/Pages/default.aspx
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
RF EXPOSURE Warning – The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 7.8 in (20 cm) from all persons and must not
be co-located or operated in conjunction with any other transmitter except in accordance with FCC and ISED multi-transmitter product procedures.
The product should not be disposed of with other household waste. Check for the nearest authorized collection centers or authorized recyclers. The correct disposal of end-of-life equipment will help prevent potential negative consequences for the environment and human health.
Any attempt to reverse-engineer this device by decoding proprietary protocols, de-compiling firmware, or any similar actions is strictly prohibited
This product is manufactured by Resideo Technologies, Inc. and its affiliates.
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
© 2021 Resideo Technologies, Inc.
R800-26838A 6/21 Rev. A Part 2