SANGOMA P325 IP Telephone Instructions

SANGOMA P325 IP Telephone Instructions & troubleshooting

SANGOMA P325 IP Telephone Instructions  & troubleshooting 1

SANGOMA P325 IP Telephone

SANGOMA P325 IP Telephone Instructions  & troubleshooting 2

Regulatory – Compliance and Agency Approval

The Sangoma IP Telephone models P325, P330 and P370 comply with or have obtained Regulatory Agency approval at least against the following standards:

EMC – Emission (Class B)

  • FCC Part 15: 2017
  • FCC 2.1093: 2015
  • ICES-003 issue 6: 2016
  • EN 55032: 2015
  • EN 61000-3-2: 2014
  • EN 61000-3-3: 2013
  • EN 301 489-1 V2.2.3: 2019
  • EN 301 489-17 V3.2.4: 2020

EMC – Immunity
EN 55035:2017

Safety

  • IEC 62368-1:2014
  • EN 62368-1:2014 + A11:2017
  • AS/NZS 62368.1:2018

Telecom

  • IC CS-03 Part 5 issue 9 + A2 + A3: 2021
  • Part 68 316: 2012
  • Part 68 317: 2011
  • AC/CA S004: 2015
  • AC/CA S040: 2015

Radio

  • EN 300 328 V2.2.2: 2019
  • EN 62479: 2010
  • FCC Part 15C: 2017
  • RSS-GEN Issue 5: 2018
  • RSS-247 Issue 2: 2017
  • RSS-102 Issue 5: 2015 + A1
  • AS/NZS 4268: 2017

Compliance and Regulatory Statements

EN55032 and CISPR32 – Statement
Theese are Class B products.

FCC Part 15 Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

    • Reorient or relocate the receiving antenna
    • Increase the separation between the equipment and receiver
    • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
    • Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with a minimum distance 20cm between the radiator & body.

IESD Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Radio Frequency Exposure Statement for IC
The device has been evaluated to meet general RF exposure requirements. The device can be used in mobile exposure conditions. The min separation distance is 20cm.

EU Directives: RED and RoHS Recast

SANGOMA P325 IP Telephone Instructions  & troubleshooting 3

UK Regulations: Radio and RoHS

SANGOMA P325 IP Telephone Instructions  & troubleshooting 4

Marking
The IP phones P325, P330 and P370 bear the following CE mark

Environmental Information

Waste Electrical and Electronic Equipment – WEEE
The WEEE (Waste Electrical and Electronic Equipment) legislation aims to raise the level of recycling of electrical and electronic equipment and to encourage designers to create products with recycling in mind.
The Sangoma equipment that you bought has required the extraction and use of natural resources for its production. It may contain hazardous substances that could impact health and the environment.
In order to avoid the dissemination of those substances in our environment and to diminish the pressure on natural resources, we encourage you to use the appropriate take-back systems. Those systems will reuse or recycle most of the materials of your end-of-life equipment in a sound way.
The crossed-out wheeled bin symbol invites you not to dispose of WEEE as unsorted municipal waste and to collect such WEEE separately.

Safety warnings and Precautions

  • Access to the interior of this unit shall be made only by a qualified technician.
  • Disconnect the appliance before opening

Making changes or modifications
Any changes and modifications not expressly approved by Sangoma will void any compliance and regulatory approval, and will void the user’s authority to operate the equipment.

FAQ


Setting up SANGOMA P325 IP Telephone Instructions is easy with these step-by-step instructions. Follow the steps are you are set-up in no time.

Using SANGOMA P325 IP Telephone Instructions is simple by using this manual. Follow the instructions one by one and everything will be fine

Is SANGOMA P325 IP Telephone Instructions stuck or not working properly? By resetting it you can set it back to the standard settings and everything should be back to normal. This works in many cases when problems arise.

This page contains the complete user instructions & manual for SANGOMA P325 IP Telephone Instructions

All symbols, colors and codes for SANGOMA P325 IP Telephone Instructions are explained in this instruction manual. You can find everything you need and moree